Browse SAE J ORFS O-Ring Face Fittings in the World Wide Metric, Inc. catalog including Nuts and Rings,Equal Fittings,Male Stud Coupling,Bulkhead. The Seal-Lok fitting meets or exceeds the strict requirements of SAE J and ISO It is an O-ring face seal type fitting that consists of a nut, a body. Thread Specification – ORFS (SAE J). TECHNICAL DATA. SAE J, ISO ORFS is O RING FACE SEAL. ORFS system consists of ORFS.
|Published (Last):||27 April 2018|
|PDF File Size:||11.51 Mb|
|ePub File Size:||8.65 Mb|
|Price:||Free* [*Free Regsitration Required]|
Purpose The sae j1453 parts of SAE Sae j1453 cover material, dimensional, and performance requirements of steel O-ring face seal Sxe connectors for tubing and the O-ring face seal interface and nut portion of hose stem assemblies for nominal tube diameters of 6 mm through 50 mm.
These connectors are sas for general application see Figures 3, 4, and 5 sae j1453 hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures.
Top Categories Terms sae j1453 Use. Click here to skip or ad will close in 15 seconds. Speed up research, capture and reuse expertise For additional sar information, visit the IHS Standards Expert page. Sae j1453 of Application These connectors are intended for general application see Figures 3, 4, and 5 and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures.
Price and Buy this Standard View Pricing.
Adapter SAE J with Swivel Nut / BSI On World Wide Metric, Inc.
SAE J covers the requirements for O-ring face seal connectors to inch stud ends along with the associated adapters, bulkhead and union connectors. For sae j1453 designs metric tubing should sae j1453 considered. For sar of these connectors in conditions outside the pressure and temperature limits specified, the manufacturers must be consulted.
Identify unmet needs and discover next-generation technologies Improve sae j1453 by leveraging consistent standards to meet customer and market requirements Minimize risk: Mitigate sae j1453 and better understand compliance regulations Boost efficiency: Sae j1453 the past, these connectors have been used predominantly with inch tubing. The three parts of SAE J sae j1453 material, dimensional, and performance requirements of steel O-ring face seal ORFS connectors for tubing and the O-ring face seal interface and nut portion of ase stem assemblies for nominal tube diameters of 6 mm through 50 mm.
This Standard References Showing 10 of Inch hex dimensions of parts will be moved from the main document to an informative annex after These connectors are capable of providing leak proof full flow connections in hydraulic systems operating from 95 kPa vacuum to working pressures shown in Table 4.
Adapter SAE J / SAE J with Swivel Nut On World Wide Metric, Inc.
This standard is available for individual purchase. IHS Standards Expert subscription, simplifies and expedites the process for finding and managing standards by giving you access to standards from over standards developing organizations SDOs. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer j14453 ensure that required performance levels are met.
The rated working pressure of a sae j1453 conductor assembly using SAE J hose stem connections or formed sae j1453 or braze-on tube connections shall not exceed sae j1453 working pressure of the lowest rated component thereof.
Since many factors influence the pressure at which a hydraulic system will or will not perform satisfactorily, sae j1453 values should not be construed as guaranteed minimums.
Both sae j1453 and inch tubing can be accommodated by changing only the sleeve j14533 match the tube diameters.